network engineer is troubleshooting a small LAN network with one border router, GW01 that connects to the Internet Service Provider’s (ISP) network.
INSTRUCTIONS TO CANDIDATES
ANSWER ALL QUESTIONS
Static and Dynamic Routing
A network engineer is troubleshooting a small LAN network with one border router, GW01 that connects to the Internet Service Provider’s (ISP) network. GW01 uses its Serial 0/2/1 interface to connect to the ISP’s router. Everyone on the LAN network lost connectivity to the Internet. Upon troubleshooting the issue, the network engineer notices the following message after typing show ip route.
Gateway of last resort required but not set.
What do you suggest the network engineer do to rectify this issue? Assume the problem is only on the organization’s LAN side of the network. Provide as much information as possible including specific commands and all required parameters in order to receive full credit. (15 points)
The show ip interface brief command executed on router1 R1 and R2 generated the following output. What would be the static route commands that you would type on R2 in order to reach R1’s subnets. Provide complete configuration command with destination prefixes and next-hop information or exit interface in order to receive full credit . Assume R1 is already configured. (15 points)