Write a sketch that edits a byte of data that is displayed on the LEDs (PORTE). The byte value should initially be 0.
Use the variable resistor on pin A0 to select the bit to edit. You will use the 3 high order bits of A0 to choose the bit (0-7) to edit.
As you turn the variable resistor, your program should use the i/o console to display the phrase "Bit #" (# would be a 0-7) to display the number currently selected on A0 .
Edit the selected bit of PORTE when a button is pressed, according to the following requirements.
Button 1: set the bit
Button 2: clear (reset) the bit
Button 3: toggle the bit
Button 4: display the state of the bit as "Bit # is state", where # is 0--7 and state is "on" or "off".
You must use bit-wise functions to edit the data byte.
DescriptionIn this final assignment, the students will demonstrate their ability to apply two ma
Path finding involves finding a path from A to B. Typically we want the path to have certain properties,such as being the shortest or to avoid going t
Develop a program to emulate a purchase transaction at a retail store. Thisprogram will have two classes, a LineItem class and a Transaction class. Th
1 Project 1 Introduction - the SeaPort Project series For this set of projects for the course, we wish to simulate some of the aspects of a number of
1 Project 2 Introduction - the SeaPort Project series For this set of projects for the course, we wish to simulate some of the aspects of a number of